I just bought what I thought was a good compass for the inside of my jeep. It
has two screws on the bottom that are supposed to be for calibration purposes
(compensating for any magnetic interference in the mounting area.) One for N/S,
the other for E/W.
The problem is that I can’t get the thing to read right in all directions.Just a
small tweak of a screw has a drastic effect on the other axis. If I get it to read
North, then get it to read east, the S and W are way the hell off. I tried to set it so
opposite directions are the same amount off the mark (ie.only remove half the
error) But if I get N,S OK then E,W is wrong, then if I tweak the E,W just a little, it
blows the N,S out again.
Does anyone have any experience with this sort of thing? ( Before I bring it
back, or throw it out.)
has two screws on the bottom that are supposed to be for calibration purposes
(compensating for any magnetic interference in the mounting area.) One for N/S,
the other for E/W.
The problem is that I can’t get the thing to read right in all directions.Just a
small tweak of a screw has a drastic effect on the other axis. If I get it to read
North, then get it to read east, the S and W are way the hell off. I tried to set it so
opposite directions are the same amount off the mark (ie.only remove half the
error) But if I get N,S OK then E,W is wrong, then if I tweak the E,W just a little, it
blows the N,S out again.
Does anyone have any experience with this sort of thing? ( Before I bring it
back, or throw it out.)